IV - Protective case for the electronics of my relived Rapman
Hello everyone.
I designed a box to protect the new Arduino + Ultimaker replacement electronics. For other boards like RAMPS, you should consult on the internet. A starting point is Thingiverse.
This box is very simple and efficient. It is made of 5mm transparent acrylic (laser cutting) so you have a formal unit with the printer and allow you to organize all the electronic components in a logical way (so they are not "pulled" on the bottom).
I reused screws, nuts and washers left over during the construction of the kit, as you can see, although they can be replaced by similar ones. Refer to the detail of the photos.
The plans (in real size):
The pictures (the box is open at the back, they will notice some differences because it was a prototype and the plans are already corrected):
Enjoy it.
No comments:
Post a Comment